Some of the test equipment
in use at the WB2FCN work area!
The HV Power supply that gets the most workout is my special job that
provides 2 KV at 300 MA. It
is adjustable by variac control. The filter system consists of
ten (10) 4700uF @ 450 VDC computer
grade caps, each bypassed with a 47K 2 watt resistor (load). I use it
for the stand alone amplifiers and
rigs that need to be tested, that come in minus power supplies.
Here are a few pictures of it:
The rectifier board is towards the rear
of the chassis.
It is a FWB and handles 2.5A at 5KV per leg.
Front view of the power supply.
Front panel controlled PTS-040
The specs are here
My Dummy Load with built-in Watt-Meter
The Low frequency / Low power
HP-Amplifier
The Newer HP Amp No range switch required.
and the Manual
A 2 - 4 Ghz. Amplifier
The TEK 190
Signal generator
W/ Attenuator
of course this is the
Attenuator
And for those "Pesky"
DX-100 rigs that like to put out more than
125 Watts of RF!
The Bird bench dummy load.
Let's not forget the "Bird"
actually (4)
Always needed is a GOOD
Frequency Counter
good to 500 Mhz.
Under Signal Generators
The HP-8640B w/option3
The Manual for parts:
The Operators and Maintainance Manual:
For realignment of the resident
R-390A receivers
the AN/URM-25D
w/accessories.
The HP-608D
I got two of these because
I "LOST" one in the basement!
This one came from Washington State
has a pressurized shipping container!
also
w/accessories.
Did I mention I have no room?
This one came from Florida and
actually made it in one piece!
Model 80 R.F. Generator
By Standard
this is a pair of them.
A Boat Anchor VOM
(Directly measures up to 5 KVDC)
Your basic "Do-All" VOM
Yes it is a TS-352
The Operators Manual:
The Parts Manual:
The Depot Service Manual:
I use a lot of different O'Scopes
here is one of my favorites
The TEK-5440
with Scope Cart
